Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

08.06.2025 09:00

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Barnstars:

This one hit behind the barn.

VMware drops the lowest tier of its partner program – except in Europe - theregister.com

This device then solves the entire problem.

In schematic diagrams this is the symbol for a fuse:

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

Why am I so triggered and depressed over a minor thing?

He then describes Rainy Season and Lightning.

2024–10–14 [Omar Gharbi Omar Gharbi ]

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

Who was the actor least deserving of an Academy Award?

Here is a simplified AC power diagram.

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

So, the voltage could go up to 500 volts, and the fuse will not open up.

Why does a narcissist act like it's nothing when they hurt you?

nine

Can the fuse protect the electronic devices from lightning instead of a surge protector.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

First American Spacewalk 60 Years Ago Today - The Weather Channel

the problem then depends on "how fast does the fuse operate?".

An AC voltage/ current source, and an ac inductive load.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

How do you feel about Donald Trump signing an executive order that says there are only two genders?

There are two important concepts here.

But it can get overloaded, and no longer works.

eight

Why do people think Justin Bieber is worse than Joseph Stalin?

I post the exact comment here.

2024–10–16 [ OO OLAOYE OYEBODE ]

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

What is the experience of wearing a school uniform every day? Do people typically get used to it or dislike it?

so, what happens?

This is 'the assistant's answer'

First Sentence:

PSA: You Probably Don't Need To Be Weighed At The Doctor's Office - HuffPost

[old diagram got deleted by accident]

A circuit breaker is similar, but is resettable.

One is “what exactly is in a ‘surge protector’ ? ”

How do you like to be pegged?

It also is a device that limits the change in current flow.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Upvotes:

Get Deals On Super Mario And Zelda Games With Free Switch 2 Upgrades - GameSpot

[image of Common-mode choke]

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

These devices are installed between the “hot” and “neutral” and protective ground.

What kind of book did you write after turning 55?

This is where the MOV conducts again, and dissipated the energy.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

The MOV will conduct when the voltage exceeds 50% of line voltage.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

At one ohm, the resistor has a maximum of 1 watt power.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

(Dc diagram shown, AC is similar).

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

For this case there are devices called Metal oxide varistors (MOV).

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

A fuse is a non-resetable over current circuit protector.

There are three different concepts here that are getting confused.

What does a fuse do?

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

It seems Mohan does not understand the difference between a comment and an Answer.

He then asserts :

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

what exactly is a ‘surge’ protector?

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

This is where this question deviates from being a 'generic' question, and becomes more specific.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

One

Now when you have a certain ac resistance, then a current flows in a loop.

The third is lightning and “how it gets conducted into a home.”

Because the load is inductive, the current lags the voltage.(by a bit).

This is the picture of an electronic coil of wire wound around a core of magnetic material.

The other is “what does a “fuse” do?”

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

At least they know the answer if they wanted it.

The bolt then partially travels down the line to your home.

Edit 2024–10.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

What is lightning?

But… the neutral is now “floating” because of the 1 ohm resistance.

2024–10–10[John johnson John Johnson ]

He then describes the function of a fuse.

a photo is worth a thousand words.

These are simplified answers to the original question, and does not change anything I wrote above.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

but I think this circuit , shows a few more pieces.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

but this device (an Inductor) … impedes the rapid changes in the current.